 |
| |
The V200E could be viewed as the first step
in building the “all in one” positioner,
by adding the basic internal Ip module, converting
the V200P to an electropneumatic V200E. This module
fits very neatly inside the housing, requiring only
two screws to secure the module to the housing.
This conversion can be made in minutes, in a shop
or in the field. This module then accepts a 4/20
mA signal and internally converts that electronic
signal to a 3-15 psi output sent into the positioner
pneumatic signal diaphragm chamber. Once the module
is installed, a 1⁄4” plug is then installed
in the pneumatic port on the side of the positioner
marked I. This also means that replacing this module
is very simple…only minutes to troubleshoot
and bring the package back in service. Calibration
and troubleshooting is made easier due to the Ip
board on this module, with easy access and the ability
to generate or read a local signal. |
|
|
 |
 |
 |
|
|
|
| V200P |
V200E |
|
|
 |
 |
|
|
|
| V200E-EX |
|
|
| V200E-FF |
|
|
 |
 |
|
|
|
| V200E-IS
|
V200E-0/10V |
|
|
 |
|
|
|
 |
|
|
|
|
|
|
|
|
| V200
Feedback Unit |
|
|
V200P-EHT |
|
|
|
 |
|
|
|
|
|
| Features |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
